How to Install a Single Handle Bathroom Shower Faucet? Single Handle Shower Faucet Installation Tips is helpful to your shower faucet replacement or repair. シングルハンドルシャワー水栓は、現代の家庭で使用される最も一般的なタイプの水栓です。. 他の2ハンドルシャワー水栓とは異なり, which have separate handles for hot water and cold water, single handle faucets allow you to control the flow of both hot and cold water through a common lever. Installing a single lever shower faucet is a fairly simple task and takes hardly 20 分. All you need to do is follow these steps.
Chrome Single Handle Shower Faucet by Sanliv
Tools and Materials Required
Single handle shower faucet
Faucet repair kit
タオル
Phillips head screwdriver
Flat head screwdriver
Needle nose pliers
ステップ 1 – Select an Appropriate Size
Before starting with the installation, measure the pipe spacing and cavity size of where the shower faucet is to be placed. Any style may be used; however the size must be accurate otherwise the faucet would not fit the holes. So note down the measurements and buy the right size.
ステップ 2 – Removal of Old Shower Faucet
Turn off the water supply before installing the single-handle shower faucet. It is advisable that a towel be placed under the opening since excess water may still be present in the pipes. After doing that, use a flat-head screwdriver to remove the plastic cap at the center of the faucet handle. 今, remove the stainless steel sleeve. Once that is done, use the Phillips head screwdriver to unscrew the faucet handle. Move the screw driver in a counterclockwise direction. Separate the handle from the faucet assembly. When this is done, remove the U-shaped clip. The U-shaped clip holds the faucet in its place in the assembly. With the help of needle nose pliers, remove the faucet.
ステップ 3 – New Single Handle Shower Faucet Installation
Before starting with the installation, place all the pieces next to you in an organized manner. This may make it simple for you to know which piece is to be placed after another. First is the faucet, followed by a U-shaped clip, stainless steel sleeve, faucet handle, and plastic cap. 今, use a pair of pliers to put the faucet into the assembly. Once that is done, slide the U-shaped clip over the faucet. On the faucet, place the stainless steel sleeve. Now fix the shower faucet handle over the faucet. Use the Phillips head screwdriver to tighten the screw of the faucet handle. It should be screwed in a clockwise direction. Do it carefully making sure the threads of the screw don’t get stuck or else the handle will not be screwed on properly. After this is done, place the plastic cap on the handle.
ステップ 4 – Turn On Water Supply
Once the installation of single handle shower faucet is complete, turn the water supply on and check for any leakage. If there is no leakage, you have installed the single handle shower faucet properly. You may then clean up the site and store away your tools safely.
