How To Fix A Bathroom Sink Pop-up Stopper Problem? When your bathroom sink pop-up waste won’t pop up or seat properly, fixing it is usually just a matter of adjusting a few parts. The problem is often a buildup of hair or other matter around the base of the stopper or the pivot rod mechanism. または, the clevis may be out of adjustment.
Bathroom Sink/basin Pop-up Waste Assembly
Here is a graphic of a typical pop-up drain assembly in a separate browser window, with all the parts labeled for identification. Here’s how to fix your Sink Pop-up Stopper Problem:
1) With a slight twist, try to lift out the stopper. If it seems to be linked to the mechanism, reach under the sink and unscrew the pivot rod retaining nut and pull out the pivot rod to disengage it.
2) Lift the stopper from the drain. Clean off all hair and debris. If the stopper is broken or its seal looks worn, replace it.
3) Face the hole at the bottom of the stopper toward the pivot rod’s location, and drop the stopper back into the drain hole. Insert the pivot rod so that it engages the hole in the bottom of the stopper, and tighten on the retaining nut with the stopper in its up position.
4) Loosen the set screw on the clevis, and adjust the strap up or down so that it operates the pivot rod to open and close the stopper. Re-tighten the set.
CAREFUL! Do not run water through the drain without replacing the horizontal arm and nut or covering the hole with a sponge. If you don’t, water will pour out of the open hole!
