• Zum Hauptinhalt springen
  • Zum sekundären Menü springen
  • Zur primären Seitenleiste springen
Bad-Küche-Faucets.com

Bad-Küche-Faucets.com

Moderne Küchenarmaturen und Badezimmer-Hardware-Designs

  • Zuhause
  • Produktkatalog
  • Über
  • Kontakt
  • Bad
    • Badarmaturen
      • Mischbatterien für Waschbecken
      • Chrom-Toilettenarmatur
      • Bidet Mixer Wasserhahn
      • Duscharmatur
      • Badewanne Duscharmatur
    • Hand Bidet Spray
    • Badezimmerschränke
    • Badezimmerzubehör
  • Küche
    • Pull-Out Küchenarmatur
    • Küchenarmaturen
    • Küchenschrank Beleuchtung
    • Edelstahlspülen
  • Wasserhähne
    • Automatischer Sensorhahn
    • Kunststoff Wasserhahn Wasserhähne
    • Single Tap Wasserhahn
    • Wasserhahn Pflege
    • Wassersparende Wasserhahnbelüfter
    • Installation und Reparatur des Wasserhahns
  • Duschen
    • Handduschköpfe
    • Handbrauseschläuche
    • Duschkopfhalter
    • Duschstange & Gleitschiene
    • Duschkabinen
    • Dampfduschraum
    • Whirlpool Massage Badewanne
  • Home Decor
    • Küchen- und Badveranstaltung
    • Reparatur des Warmwasserbereiters
  • Plumbing Supplies
    • Geflochtene flexible Schläuche
    • Messingwinkelventil
    • Klempnerservice
    • Pop-up-Abfallablauf
Du bist hier: Zuhause / Anleitung zur Pflege oder Wartung des Wasserhahns / Gemeinsame Teile für die Reparatur von Wasserhähnen oder Armaturen

Gemeinsame Teile für die Reparatur von Wasserhähnen oder Armaturen

Gemeinsame Teile, die für die Reparatur von Wasserhähnen und Armaturen benötigt werden. Die Teile von vier Arten von Wasserhähnen und wie man sie repariert. Küchenarmatur oder Badarmaturen können ein störendes Leck verursachen, das repariert werden muss. Es gibt vier verschiedene Arten von Wasserhähnen, und je nach Typ, den Sie haben, Jedes hat einzigartige Teile, mit denen Sie sich vertraut machen sollten. Die vier Arten von Wasserhähnen sind (1) Compression-Type (2) Disc-Type (3) Ball-Type (4) Sleeve-Type Cartridge.

kitchen faucet and bathroom plumbing fixture repair parts

The compression-type faucet is probably the most basic type of the four faucets. The mechanics of the faucet are three parts, the retaining nut, threaded spindle, and an O-ring. Remove the index cap and the faucet handle for access to the threaded spindle and clean with a wire brush. Replace the O-ring and check washers and screws for wear; replace as needed. Reassemble the faucet and the leak should be repaired.

A disc-type faucet has two parts, the cap and the cylinder. The cylinder has three openings, and inside these three openings are three rubber seals. Remove the seals with the tip of a screwdriver. Using a scouring pad, clean the cylinder and the seals, and then rinse the cylinder and the seals in water. Put the seals back in the cylinder and reassemble the faucet. If the faucet continues to leak then replace the cylinder.

A ball-type faucet draws its name from the ball that controls the water flow. A ball-type faucet has four parts. The cap covers the cam and the cam washer, and underneath the cam washer is the ball. Repairing a ball-type is slightly more difficult than repairing a compression-type or disc-type faucet because of the extra tools needed. It is recommended you buy the repair kit for this type of faucet. Using a pair of water-pump pliers, also known as channel-locks, loosen the faucet handle setscrew and remove to allow access to the faucet cap. A special tool that comes with the faucet repair kit called a cam tool is used to remove the faucet cam. You then take out the faucet cam; the cam washer and the rotating ball, checking the ball for wear. Underneath the ball you will notice some springs and valve seats, the spout will now slip over the top of the faucet base allowing easier access. Take off the old O-rings wrapped around the base and put in the new ones. Remove the old springs and valve seats and replace with the new ones. Reassemble the faucet assembly and your leak is fixed.

Sleeve-type faucets have three parts, the retaining ring, a cartridge, and the cartridge seal. This also a faucet that will require a repair kit for repairs. The first step is to remove the faucet handle and take off the threaded retaining ring using water-pump pliers. If there is a retaining clip in place be sure to remove that also. Take a pair of pliers and pull the cartridge up from the base. Install the replacement cartridge making sure the tab on the cartridge is facing toward you. Take off the spout, remove, and then replace any O-rings. Reassemble the faucet.

Fixing the leaking faucet takes a little knowledge, the right tools, and some patience. But doing it yourself will save you money, and give you the personal satisfaction of knowing you fixed that leaky faucet yourself, and that is not always an easy task.

DAS KÖNNTE DIR AUCH GEFALLEN

  • Plumbing Faucet Fixture Parts-A03
    Teile der Sanitärarmatur-A03
  • Chrome Bathtub Shower Faucet Replacement and Installation
    Badarmatur Teile, Wasserhahngriff und mehr
  • Faucet Fixture Parts & Accessories-A02
    Faucet Fixture Parts & Accessories-A02
  • Fixing A Leaking Kitchen Faucet
    Reparaturen und Befestigungstipps für Küchenarmaturen
  • Black Bathtub Shower Mixer with Swivel Spout
    Wesentliche Teile und Komponenten für Wannenarmaturen
  • Where To Find The Best Kitchen Repair Parts
    Kaufen Sie die besten Ersatzteile für Küchenarmaturen bei Sanliv.com
  • kitchen faucet and bathroom plumbing fixture repair parts
    Küchenarmatur Patrone verstopft
  • Ball-type Bathroom Sink/Basin Faucet Repair
    Reparieren eines undichten Waschbecken Wasserhahns: Ball-type…
  • Faucet Types and Faucet Repair
    Wasserhahnarten und Wasserhahnreparatur
  • kitchen-faucet-cartridge
    Tipps zum Ersetzen der Küchenarmaturpatrone
  • Kitchen Faucet Handle Replacement or Repair Steps
    Austausch- oder Reparaturschritte für Küchenarmaturengriffe
  • Delta Kitchen Faucet Repair photo
    Anweisungen zur Reparatur von Delta-Küchenarmaturen

Abgelegt unter: Anleitung zur Pflege oder Wartung des Wasserhahns, Installation und Reparatur des Wasserhahns Markiert mit: Wasserleck beheben, Reparieren eines undichten Wasserhahns, Undichte Wasserhahnreparatur

Primäre Seitenleiste

Durchsuche die Seite

Übersetzung

EnglishDeutschEspañolPortuguêsFrançaisItalianoРусскийالعربية日本語
Als Standardsprache festlegen
 Bearbeiten Übersetzung

Sanliv Onlinestore

Twin roll toilet tissue paper holder

Armaturen

  • Automatische Armaturen
  • Badezimmerzubehör
  • Klappbare Duschfußstütze
  • Küchenarmatur
  • Vergrößerungsspiegel Make-up
Sanliv Duschfußstütze,Eckfußstütze zum Rasieren von Beinen,Gerändelte Messing-Fußstufen-Duschleiste,Gebürstetes Nickel
Einhand-Badewannen-Duschmischer
Hotel Handtuchhalter Organizer WC Wandregal Nickel gebürstet
Philippe Stark Wasserhähne: Axor Starck Organic von Hansgrohe
Einhebel-Küchenarmatur zum Herunterziehen, goldfarben gebürstet
Sanliv Duschfußstütze zum Rasieren der Beine,Wandmontierte Duschstufe Fußstütze,Gerändelte Stangenfußhalterleiste aus Messing,Matt-schwarz
Mattschwarzer Einlochgriff Waschbecken Wasserhahn
Einhand-Küchenarmatur zum Herunterziehen, gebürstetes Nickel

Urheberrechte © © 2025 Bad-Küchen-Armaturen.com mit Seitenverzeichnis